(obviusly you can use any % of power and any item in the chest). Reading the content of the top-right chest and connecting it with the power-switch will let you connect the power to your steam engines when the power in the accumulator drops to 20% and disconnect the switch when the power hit 100%. Doing this, the item will remain in the top-right chest when the power goes from 20 to 100, and then moved back in his starting position, where it stays until the power goes back to 20%. 1077 Power Book - Compact, Tileable, No Waste Nuclear, Solar, Steam. 1084 The Complete Belt Series: Red, Part 2. 1321 The Complete Belt Series: Yellow, Part 1. What this does is: the one item is moved from his starting position when the power hit 20% and then moved back when it reach 100% (The 2 inserter in the middle are always active, and they are used to give the space to put the 2 controlled inserters). 1536 The Complete Belt Series: Blue, Part 3. ago Are they connected to something that needs power 2 level 2 Op 6 yr. if you can provide a screen shot it will help out a lot 3 level 1 6 yr. Each combinator is connected to one inserter, as you can see in the image. 1 water pump into a straight line of 14 boilers into a straight line of 10 steam engine add fuel and make sure that they are connected to something the draws power otherwise no power will generate. One of the two combinators give a signal when the power=20% and the other when the power=100%. I'll try to explain it as best as i can, here is the image: īasically the accumulator is connected to two combinators, and the % of the power is given to the signal P. (Probably there is a better solution for this out there, something fancy with a lot of logic behind it). After some research i didn't found a setup that pleased me, and i had an idea for one. If you simply read the " of one accumulator and set up a switch that is activated only when the % goes below a certain value, when the % reach that value the switch will continiusly switch instantaniusly.
FACTORIO STEAM ENGINE SETUP FULL
This is a little setup that let you disable your steam engines when your accumulator are full and activate them when the power goes below a certain %.
0 kommentar(er)
